Vapeupuk

Vape, eliquid, mods, esig and more reviews

GeekVape Zeus X RTA
Blog

GeekVape Zeus X RTA

GeekVape Zeus X RTA

Today I have an interesting guest who has already reincarnated many times and has a decent army of fans. Frankly speaking, the last experience with his brothers was a long time ago, however, I still try to compare them a little.

GeekVape Zeus X RTA ...

Case material: stainless steel
Atomizer type: RTA
Capacity: 3.5 / 4.5ml
Diameter: 25mm fit / 26.5mm maximum / 29mm dough glass
Height: 43mm with dark drip type / 39mm without drip type
Connector: 510, pin is gilded
Weight: 61g
Color: see photo below

GeekVape Zeus X RTA ...

Options
– Zeus X RTA
– pre-wired spirals 2pcs
– cotton 2 laces
– hexagon
wrench – screwdriver wrench
– spare origins
– spare screws
– spare glass
– additional 810th drip type
– adapter for 510th drip types
– user manual
– certificates, etc.

Feel ???  - GeekVape Zeus X RTA ...

I can not say about the equipment – It’s just gorgeous, there is everything to start, as well as for the small-scale customization of the tank.

Our guest looks decent. I don’t even know why, but I liked it. It is likely that the impression is now smoothed by the rounded, unlike its predecessors, geometry of the lid, as well as a very original predefined drip type.

Dimensions in width are decent, especially with dough glass. And even without it, when you hold it in your hand, it seems that it is something solid, powerful. Accordingly, the weight of the device turned out to be somewhat large. On light modes, it can outweigh, although it is unlikely to happen with the two-janitor, for which he is most likely designed.

GeekVape Zeus X RTA

Dripe types two, both 810th landing. One is made of delrin, the second of the ultem, the latter is slightly higher. Although I liked the dark version more visually, it collects much more condensate than its translucent counterpart. An adapter for the 510s was also installed, but I don’t know why it is needed here.

GeekVape Zeus X RTA ...

The cover is quite massive, the locking mechanism is half-turning. It’s easy to get in, for convenience there are mild risks. Under the cover there are two small holes for refueling. You see how they are recessed below the edges of the tank, and inside the shaft rises, so the nozzles of the bottles do not penetrate directly into the holes, hovering above them. I will not say that this creates difficulties when refueling, but it was probably not worth lowering them so low. Naturally, the blame is on the cover design.

GeekVape Zeus X RTA ...

Tightening adjustment ring with stopper, it is removable. The move is quite tight, although there are risks. Therefore, inadvertently, by adjusting the airflow, you can open the lid. I will not call this moment critical, since it happens quite rarely, at least for me. The size of the air inlets is 13 x 2mm.

The puff turned out sooo free, I covered it a little more than half. And I would like to cover more, but then the steam is very hot and the taste is lost.

The tank capacity is not the greatest, it can be increased due to the complete dough of glass. And even with it, the tank eats jelly decently, it is understandable, nevertheless, two spirals.

Feel ???  - GeekVape Zeus X RTA ...

As you understand, the impenetrable construct of our hero obliges him to have a double dome. Internal processing of the latter under the cone. The shaft diameter is approximately 7.5 mm, and the diameter of the dome at the base is 17 mm. It is inserted into the larger one and fixed by the oring, but remains movable to rotate the base when it is wound. On its sidewall there are three rows of holes, and so the lower two rows are beaten on the side of the coil, and the upper one is obtained, as it were, from above – at an angle to the deck.

LEAVE A RESPONSE

Your email address will not be published. Required fields are marked *